USED PARMA WORK A MATIC VERTICAL GRAVITY FEED BAND SAW

NOT HORIZ BUT VERT GRAVITY FED CUT OFF SAW
Angle Plate Block
Model: Roll-A-Matic
115VAC
60 Hz
Single Phase
Work Piece Size: approx. 8"
Gravity Feed
Metal Cutting
Vertical
Blade XC Length: 9'9"
3/4 Hp
Table: 29" x 18"
Table Height 35 3/4" from floor
Swivel angle block to CLAMP to
Mfg since 1948
Roll around on casters

Information on line but should be verified:
The Parma Manufacturing Co., Inc. has an interesting history.
The company was established in 1940 and had locations in both Parma, Michigan and Cleveland, Ohio.
In 1948, they began producing a gravity-fed metal-cutting bandsaw that had been patented by Carl A. Furtwangler.
Fast forward to 1999, the rights to this gravity-fed saw were acquired by Dake Corp., which continues to sell it as the “Work-A-Matic SXC” gravity-fed bandsaw, sometimes referred to as the “SXC Parma” saw.